描述

Please leave your contact details, including email address.

We will send the MAC address program. Please let me know the MAC address and I will send the licensed program.

Specifications: Pulse frequency: 250kHz, error: 3um

Feed width varies depending on the feed rate is changed, please let us know jimyeo feed width. The default width is 200 pulses per rotation feed 1mm.

By applying different serial ports you can drive multiple control programs in one computer.

There are commands to the init, open, run, simul, wait, close. Type the command and press Enter or the space bar you can control the program.

init sets the serial port, and enter the parameters for setting the coordinates. Press the button to change the current coordinates can be set. open open a G code file is loaded.

run by transmitting motor driving profile generated based on the G-code file is a control program loaded in the CNC controller to drive the motor through the motor drive circuit.

simul is based on a virtual drive loaded G-code file. wait stops the motor. close Closes the loaded G-code file.

For example, by using the init operation sets the current coordinates and the serial port, using open G, open the code file, or by using the simul run, you can run the operation control based on the G-code file. Further, after the pause of the operation by entering the wait it can be returned to operation control by entering the run again. If it stops the operation of the motor control and urgently party will cut off the power supply or lowering the wait command in the control program. If you have any inquiries or questions please mail to xtrim@paran.com.

FashLed has an Arduino Uno programs

Go to coordinate the CNC control on the upper right, G code to open, run, stop, set point, and the Z axis zero setting.

If you require an emergency stop, press the stop.

Hardware Configuration

Install the program to the Arduino Uno, and set the communication port.

Combine the Arduino Uno board, and connect with GRBL and test a bipolar stepper motor.